Security light sensor adjustment

Make sure your motion- sensor security lights only trigger when you want them to. B00KEHMCfor more information. This video walks you through trouble shooting steps to adjust your light sensor. They make your house safer, TURN THE LIGHT ON WHERE YOU appear and turn it off when you leave, saving energy.

Learn the fine art of motion detector sensor adjustment and stop wasting energy illuminating passing cars and wandering neighborhood cats.

By the DIY experts of The Family Handyman Magazine.

One of the best things about an outdoor security light is that you can set it to be on only when you want it to be.

If your light came with built-in controls then you will work with . The controls on major brands available allow you to calibrate the motion sensors in terms of sensitivity, the area monitored and how long a . Skobel Homes shows you how to test and program your exterior flood lights. How can activate my sensor lights to work only at night time. P can you also do something about security camera? Once your motion security light is installed it is time to select the modes and settings that are best for your situation. Learn about the different operating modes and follow these simlpe steps to properly adjust the motion sensor for optimal detection.

Tips for adjusting the sensor settings is also covered. PIR sensor any subsequent detection will start the timed period again from the beginning. Rotate the LUX knob anticlockwise from light ( ) to dark ( ). The Solar panel is the power source for the SOLAR. Loosen the Cope Stud before rotating the PIR sensor.

Adjust the detection area by rotating the PIR sensor. Adjusting the LUX control level: ( ) position denotes that the PIR can switch the floodlight on . How to adjust the LUX and TIME settings. How to keep your motion sensor light from going out you when you need it to stay on. Timing is everything, funny when the lights go out during your first vid.

Setting up your Simx Sensor or Sensor Light. PDL PIR Sensors have three modes of operation: AUTO MODE. The sensor is now in Automatic Mode and will operate according to the pre-set Time, Sens (where available) and Lux adjustment. During extreme weather conditions the motion sensor may exhibit unusual behaviour. Note: When the first use of the three adjustment switch to the maximum value, power after the lights and so on after the lights go out to work and can be adjusted . Tap on the settings Gear icon for the Kuna light you want to adjust in the Cameras tab.

Then, scroll down to the Motion Sensitivity section.