Light pole base depth

Pole Base (40” tall), 24” square, Cd=1. The following factors and assumptions were used in the . They are every- where and generally, they look terrible. That is why we created something that looks remarkable.

We have three standard textures: Ledgestone, Flute and Smooth.

And for those looking for something truly unique, we offer an .

Bases of light poles are circular in shape.

Determine the size of the light pole base by calculating its area in square inches. This can be done even if the base of the light pole is inaccessible because the pole is upright. Finding the circumference, or distance aroun the base allows determination of the . DEPTH AND DIAMETER OF FOOTING SHALL VARY BASED ON SOIL TYPE.

HOUSEKEEPING PAD: DIMENSIONS FOR HOUSE KEEPING . Light Pole Materials shall be as follows: Poles. Pole Connection Extrusions, Bars and Plates. Frangible Transformer Base Casting. Nuts for Connection Bolts and Anchor Bolts.

SPECIFIC CONDUIT AND WIRE REQUIREMENTS. REVIEW SOIL CONDITIONS AND ADJUST BASE. LAMPS, CONTRACTOR SHALL PROVIDE CONCRETE. DESIGN TO SUIT SOIL CONDITIONS.

OWNER FURNISHED LUMINAIRES, POLE ,. Find Lateral Pressure for Given Depth : In this mode, the module will calculate the lateral earth pressures caused by the specified pole size, embedment depth and applied loads. Foundation applies only to slopes of 1:or flatter. STANDARD FOUNDATION TYPES FOR STREETSCAPE POLES.

Make The Hole: Generally holes should be round with smooth vertical sides consisting of undisturbed soil for best compaction and stability of poles. Diameter of holes should be about twice the diameter of the pole at its base. Holes should be hand dug or augured.

For general burial depth consult the chart below: . Large spaces between the pole base plate and the concrete can cause excessive stresses in the anchor bolts. United Lighting Standards cannot be responsible for decisions made regarding the installation, embedded depth or factors related to the specific site location. A hole is drilled into the ground for receiving the light pole base. The diameter of the hole is based on the diameter of the base and the depth of the hole is . Allow to cure for minimum of hours 7. Pack this down so that it is well compressed 10.

Ensure no damage of the texture, or staining, cracking, chipping, etc.