If your pool light will not turn on and you suspect the bulb, the old shake test is simple enough for any pool owner to do. You can sometimes see water or condensation on the light lens. If there are multiple lights this can help . Recent news stories have been published about swimming pool safety and pool lights.
This video goes over just about everything you need to know Before you replace your pool light.
It includes trouble shooting tips as well as advice based on first hand experience.
Do Not attempt this unless you are and experienced handyman.
How to reset GFCI for Pool lights not working. I reset GFCI , and turn the light on, and it trips again. Be sure that the outlets that may be on the same GFCI circuit are covered to help prevent this. If, after turning on the pool light switch, the GFCI trips , the most likely cause is water inside your light fixture.
When that maximum load is exceede the circuit breaks open, and the breaker trips , which cuts off power to your pool lights. Frequently, a GFCI outlet is wired into the UW light circuit. Ensure all of these switches are in the ON position.
If anyone has any ideas about what could be causing this . Are your swimming pool lights not working? It may be time to reset the GFI for the circuit. If the GFCI trips , then you will need to press the reset button to restore electricity back to your equipment.
Diagnose faulty pool lights safely and accurately before repair or replacement. Step 1: With the power on (circuit breaker and switches), test and reset the GFCI. But the fixture still may function reliably without tripping the GFCI , especially if the ground fault is in the neutral line. A friend of mine has an inground pool. The last few days the pump has been tripping the GFCI breaker.
He reset the breaker and the pump would run for a. The other of the time, you actually start to get shocke and the GFI trips power off. A dangerous condition may exist.
No comments:
Post a Comment
Note: only a member of this blog may post a comment.